Extended T-Visor replacement t-visor Fits some Pre Vizsla style

Fits some Pre Vizsla style 1:1 scale helmets

Fits Havoc helmets as well as others

Measurements-Top horizontal section along the curve:  9 & 1/4″Top horizontal section height (top to bottom):  1 & 7/8″(ends) to 2 & 1/2″ (toward middle)Middle vertical section from top to bottom:  5 & 3/8″Middle vertical section width (left to right):  1″ (bottom) 2 & 3/4″ (were it meets horizontal section)REMEMBER: T-Visors are installed from the inside of the helmet so a little bit of overlap is a good thing

Measurements-Top horizontal section along the curve: 10″Top horizontal section height (top to bottom): 1″(ends) to 2 & 5/8″ (toward middle)Middle vertical section from top to bottom: 7 & 3/8″Bottom of middle vertical section width (left to right): 2 & 3/4″ (under horizontal section) 2 & 1/4″ (bottom)REMEMBER: T-Visors are installed from the inside of the helmet so a little bit of overlap is a good thing

Extended T-Visor replacement t-visor Fits some Pre Vizsla styleMeasurements Top horizontal section along the curve: 11 & 1 8Top horizontal section height (top to bottom): 1 & 3 8(ends) to 1 & 5 8 (toward middle)Middle vertical section from top to bottom: 6 & 7 8Middle vertical section width (left to right): 2 & 5 16REMEMBER: T Visors are installed from the inside of the helmet so a little bit of overlap is a good thing. Laser Cut! Fits FP, MSH1, Sgt Fang helmets as well as many others.