Replacement Power Vent Motor for EGV6, ERV6 Series 42 Inch Deck D of cut and 30

D of cut and 30 in

175 mm) Wear Layer 3 mil Edge Type Straight edge Finish Gloss Low gloss Installation Method Adhesive Installs Over Subfloor Concrete

3 GPM from a 173cc 4-stroke OHV engine

This saw is powered by our largest 15 Amp Dual-Field high torque motor so you will make the last cut as precisely as you did the first cut

Replacement Power Vent Motor for EGV6, ERV6 Series 42 Inch Deck D of cut and 30The PVM112 motor is the replacement motor for the Master Flow Power roof Vents (ERV6 series) and Power Gable Vents (EGV6 series). This upgraded PSC (Permanent Split capacitor) motor is easy to install with the power vent in place, no need to remove power vent. Minimal tools needed for replacement. PSC motor more efficient than standard shaded pole motors Replace old motor quickly Leave power vent in place while replacing, no need to remove entire unit